Question: Where do I attach my pool vacuum hose?

How do I attach a hose to my pool vacuum head?

2:229:29How to Vacuum Your Pool - YouTubeYouTubeStart of suggested clipEnd of suggested clipGoes on to the vacuum head just push that on there as tight as you can. And again you dont need anyMoreGoes on to the vacuum head just push that on there as tight as you can. And again you dont need any hose clamps or anything for this because the suction is actually gonna pull it tighter.

Which end of hose goes on pool vacuum?

Other times the hose is installed backwards. The swivel end goes on the vac head in to the pool and the non-swivel end goes onto the skim vac plate. If you have a new hose and the right end is in the pool and its still not working, you may need to backwash the filter or clean your cartridge(s) or DE Grids.

Why is my pump losing prime when I vacuum my pool?

If theres a hole near the top of the hose and its near the surface its going to suck in air thats going to cause you to lose prime. Thats a very common spot for air to get in especially when you connect the vacuum hose and increases that pressure, it could pull in air and cause the pump to lose its prime.

Why do I keep losing suction on my pool vacuum?

Clogged tubes are one major reason why your pool vacuum lose suction. Vacuum hose connection and length can affect its performance. If your hose length is too short with the size of the swimming pool, then suction performance will be affected. Measure your pool size so does your pool cleaner hose to avoid the problem.

Write us

Find us at the office

Picardi- Katzung street no. 53, 78168 Tegucigalpa, Honduras

Give us a ring

Adella Nellums
+70 210 301 534
Mon - Fri, 10:00-14:00

Contact us